POWER MANAGEMENT CONTROL ECU INSTALLATION

CAUTION / NOTICE / HINT

Tip:

A bolt without a torque specification is shown in the standard bolt chart (Click here).

PROCEDURE

  1. INSTALL POWER MANAGEMENT CONTROL ECU

    1. Attach the 2 claws to install the power management control ECU.

  2. INSTALL ECU INTEGRATION BOX RH

    1. Install the ECU integration box RH with the 2 nuts and bolt.

    2. Attach the clamp.

    3. Connect all the connectors.

      Note:

      • Do not twist the connectors of ECU when connecting them.

      • Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

  3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

    Click here

  4. INSTALL TELEMATICS TRANSCEIVER

    Click here

  5. INSTALL INSTRUMENT PANEL BOX ASSEMBLY

    Click here

  6. INSTALL INSTRUMENT PANEL BOX DOOR COVER

    Click here

  7. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  8. INSTALL LOWER INSTRUMENT COVER LH

    Click here

  9. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  11. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  12. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  13. INSTALL FRONT NO. 2 CONSOLE BOX INSERT

    Click here

  14. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  15. INSTALL COWL SIDE TRIM BOARD RH

    Click here

  16. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

    Click here

  17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  18. CHECK SRS WARNING LIGHT

    1. Check the SRS warning light (Click hereClick here).