NAVIGATION SYSTEM(for HDD) Current Position Display does not Appear

PROCEDURE

1. CHECK HARD DISK DRIVE (OPERATION CHECK)

   1. 

      *a

      Result

      Enter the "Failure Diagnosis" screen

      Click here

   2. Select "HDD Check" and check the result.

      OK

      "OK" is displayed.

      Tip:

      After "HDD Check" is selected, it may take a while until the result is displayed.

      Result

      Result
      OK
      NG

   NG

   REPLACE HARD DISK DRIVE

   Click here

   OK

2. CHECK CABIN

   1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

      Tip:

      • A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

      • The navigation system may not operate normally when the temperature is -20°C (-4°F) or less, or 65°C (149°F) or higher.

      OK

      Condensation is not likely being produced and the temperature is not high or extremely low.

      Result

      Result
      OK
      NG

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

   Click here

   NG

   SET CABIN TO APPROPRIATE TEMPERATURE