FRONT TURN SIGNAL LIGHT BULB REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT TURN SIGNAL LIGHT BULB


    1. Turn the steering wheel fully to the right.

      Tech Tips

      When removing the front turn signal light bulb of the headlight assembly RH, turn the steering wheel to the left.

    2. A01OCO3C01
      *a 90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    3. Remove the 2 screws and separate the front fender liner.

    4. A01OCRQ

      Turn the headlight cord with the front turn signal light bulb as shown in the illustration to disconnect them as a unit.

    5. A01ODJX

      Remove the front turn signal light bulb from the headlight cord.

  2. INSTALL FRONT TURN SIGNAL LIGHT BULB


    1. A01ODJX

      Install a new front turn signal light bulb to the headlight cord.

    2. A01OCNL

      Turn the headlight cord with the front turn signal light bulb as shown in the illustration to connect them as a unit.

    3. A01OCFVC01
      *a Correct
      *b Incorrect

      Install the 2 screws.

    4. Install the front fender liner with the pin hold clip as shown in the illustration.

    5. Turn the steering wheel to its original position.