FRONT PASSENGER SIDE POWER WINDOW SWITCH INSPECTION

PROCEDURE


  1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY


    1. for Models with jam protection function on driver door window only:


      1. A01LGCZC01
        *a

        Component without harness connected

        (Power Window Regulator Switch Assembly)

        Check the switch function.

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition

        1 (D) - 4 (SD)

        2 (B) - 7 (U)

        		 UP Below 1 Ω
        Not operated 10 kΩ or higher

        1 (D) - 2 (B)

        3 (SU) - 7 (U)

        		 DOWN Below 1 Ω
        Not operated 10 kΩ or higher

        1 (D) - 4 (SD)

        3 (SU) - 7 (U)

        		 OFF Below 1 Ω

        If the result is not as specified, replace the power window regulator switch assembly.

      2. A01LGCZC02
        *a

        Component without harness connected

        (Power Window Regulator Switch Assembly)

        Check that the LED illuminates.

        Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 6 (ILL+)

        Battery negative (-) → 5 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the power window regulator switch assembly.

    2. except Models with jam protection function on driver door window only:


      1. A01LCFKC02
        *a

        Component without harness connected

        (Power Window Regulator Switch Assembly)

        Check the switch function.

        Measure the resistance when the switch is operated according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition

        2 (IG) - 4 (DOWN)

        5 (UP) - 7 (GND)

        7 (GND) - 8 (AUTO)

        		 Auto UP Below 1 Ω
        Not operated 10 kΩ or higher

        2 (IG) - 4 (DOWN)

        5 (UP) - 7 (GND)

        		 Manual UP Below 1 Ω
        Not operated 10 kΩ or higher

        2 (IG) - 5 (UP)

        4 (DOWN) - 7 (GND)

        		 Manual DOWN Below 1 Ω
        Not operated 10 kΩ or higher

        2 (IG) - 5 (UP)

        4 (DOWN) - 7 (GND)

        7 (GND) - 8 (AUTO)

        		 Auto DOWN Below 1 Ω
        Not operated 10 kΩ or higher

        2 (IG) - 4 (DOWN)

        4 (DOWN) - 5 (UP)

        		 OFF Below 1 Ω

        If the result is not as specified, replace the power window regulator switch assembly.

      2. A01LCFKC01
        *a

        Component without harness connected

        (Power Window Regulator Switch Assembly)

        Check that the LED illuminates.

        Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 3 (ILL+)

        Battery negative (-) → 1 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the power window regulator switch assembly.