LANE DEPARTURE ALERT SYSTEM(w/ Steering Control), Diagnostic DTC:C1A72

DTC Code DTC Name
C1A72 Communication Error from FCM to Driving Support ECU

DESCRIPTION

If a communication error between the driving support ECU assembly and forward recognition camera is detected, DTC C1A72 is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1A72

Communication Error from FCM to Driving Support ECU

2 seconds after the ignition switch is turned ON, a communication error between the driving support ECU assembly and the forward recognition camera is detected.

  • CAN communication system

  • Forward recognition camera

  • Driving support ECU assembly

CAUTION / NOTICE / HINT

Note:

  • When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

  • If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera learning.

    Click here

  • When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

  • First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.

    Click here

PROCEDURE

  1. CHECK DTC OUTPUT

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / LKA/LDA / Trouble Codes.

    5. Clear the DTCs.

      Click here

      Chassis > LKA/LDA > Clear DTCs

    6. Make sure that the DTC detection conditions are met.

      Tip:

      If the following procedure is not performed, the previously output DTC cannot be detected.

      1. Turn the ignition switch is turned ON and wait 2 seconds or more.

    7. Check for DTCs.

      Click here

      Chassis > LKA/LDA > Trouble Codes

    Result

    Result

    Proceed to

    DTC C1A72 is output

    A

    DTC C1A72 is not output

    B
    B

    USE SIMULATION METHOD TO CHECK

    Click hereClick here

    A

  2. REPLACE FORWARD RECOGNITION CAMERA

    1. Replace the forward recognition camera.

      Click here

    2. Adjust the forward recognition camera.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  3. CHECK DTC OUTPUT

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / LKA/LDA / Trouble Codes.

    5. Clear the DTCs.

      Click here

      Chassis > LKA/LDA > Clear DTCs

    6. Make sure that the DTC detection conditions are met.

      Tip:

      If the following procedure is not performed, the previously output DTC cannot be detected.

      1. Turn the ignition switch is turned ON and wait 2 seconds or more.

    7. Check for DTCs.

      Click here

      Chassis > LKA/LDA > Trouble Codes

    Result

    Result

    Proceed to

    DTC C1A72 is output

    A

    DTC C1A72 is not output

    B
    A

    REPLACE DRIVING SUPPORT ECU ASSEMBLY

    for LHD:Click here

    for RHD:Click here

    B

    END (FORWARD RECOGNITION CAMERA WAS DEFECTIVE)