REAR POWER WINDOW SWITCH INSPECTION

PROCEDURE

  1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

    U122438E01

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      6 (UP) - 1 (GND)

      Manual up operation

      Below 1 Ω

      7 (DOWN) - 1 (GND)

      Manual down operation

      Below 1 Ω

      8 (AUTO) - 1 (GND)

      Auto up/down operation

      Below 1 Ω
      Table 1. Text in Illustration

      *1

      Component without harness connected

      (Power Window Regulator Switch)

      • If the result is not as specified, replace the rear power window regulator switch assembly.

    2. Check that the LED illuminates.

      1. Apply battery voltage to the regulator switch and check that the LED illuminates.

        OK

        Measurement Condition

        Specified Condition

        Battery positive (+) → 4 (LED)

        Battery negative (-) → 1 (GND)

        LED illuminates

        • If the result is not as specified, replace the rear power window regulator switch assembly.