HEATED OXYGEN SENSOR(for Sensor 2) INSTALLATION

PROCEDURE

1. INSTALL HEATED OXYGEN SENSOR (Sensor 2)

   1. Using SST, install the heated oxygen sensor (sensor 2) to the front exhaust pipe assembly.

      

      *A	w/o Catalytic Converter	*B	w/ Catalytic Converter
      *a	Torque Wrench Fulcrum Length	-	-

      09224-00011

      Specified tightening torque

      44 N*m

      449 kgf*cm

      32 ft.*lbf

      Note:

      If the heated oxygen sensor (sensor 2) has been struck or dropped, replace it.

      Tip:

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 260 mm (10.2 in.)):

        39 N*m (398 kgf*cm, 29 ft.*lbf)

   2. Engage the 2 wire harness clamps.

   3. Connect the heated oxygen sensor (sensor 2) connector.

2. INSPECT FOR EXHAUST GAS LEAK

   Click here