RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT HEADLIGHT DIMMER RELAY


    1. B005954

      Remove the headlight dimmer relay from the engine room relay block.

    2. B00589ON01

      Inspect the headlight dimmer relay.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the headlight dimmer relay.

    3. Install the headlight dimmer relay to the engine room relay block.

  2. INSPECT NO. 2 HEADLIGHT RELAY


    1. B0056Y2

      Remove the No. 2 headlight relay from the No. 2 engine room relay block.

    2. B00582ON01

      Inspect the No. 2 headlight relay.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the No. 2 headlight relay.

    3. Install the No. 2 headlight relay to the No. 2 engine room relay block.

  3. INSPECT FOG LIGHT RELAY


    1. B0056XZ

      Remove the fog light relay from the No. 2 engine room relay block.

    2. B00582ON01

      Inspect the fog light relay.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the fog light relay.

    3. Install the fog light relay to the No. 2 engine room relay block.

  4. INSPECT REAR FOG LIGHT RELAY


    1. Remove the multi-display assembly.

      Click here

    2. B005AR0

      Remove the rear fog light relay from the instrument panel relay block.

    3. B00582ON01

      Inspect the rear fog light relay.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the rear fog light relay.

    4. Install the rear fog light relay to the instrument panel relay block.

    5. Install the multi-display assembly.

      Click here