REAR DOOR BELT MOULDING REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)


    1. A01DZFB

      Using a moulding remover, detach the 2 clips and 2 claws and remove the rear power window regulator switch assembly with rear door armrest base panel.

    2. Disconnect the connector.

  2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    1. A01E2OFE01
      Text in Illustration
      *1 Protective Tape

      Insert a clip remover between the plate and trim board.

      Tech Tips

      Tape the clip remover tip before use.

    2. Turn the handle clockwise to remove the snap ring, rear door window regulator handle and plate.

  3. REMOVE DOOR PULL HANDLE


    1. A01DZTY

      Remove the screw and door pull handle.

  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01E2MK

      Remove the clip and screw.

    2. Detach the 9 clips and remove the rear door trim board.

  5. REMOVE REAR DOOR OUTER GLASS WEATHERSTRIP LH


    1. A01E2Y1E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the rear door outer glass weatherstrip.

    2. Detach the 4 claws and remove the rear door outer glass weatherstrip.