IMMOBILISER SYSTEM(w/ Entry and Start System), Diagnostic DTC:B279C

DTC Code	DTC Name
B279C	Theft Deterrent System Presence Detection

DESCRIPTION

If an ECM that is incompatible with the immobiliser system is installed, the ECM stores this DTC.


DTC No.	Detection Item	DTC Detection Condition	Trouble Area	Note
B279C	Theft Deterrent System Presence Detection	An ECM that is incompatible with the immobiliser system is installed (1-trip detection logic*).	ECM	DTC output confirmation operation: Check for DTCs.

Table 1. Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected	Fail-safe Function when Malfunction Detected
Engine cannot be started	-

Table 2. Related Data List and Active Test
DTC No.	Data List and Active Test
B279C	-

CAUTION / NOTICE / HINT

Note:

When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."

PROCEDURE

CLEAR DTC

Clear the DTCs.

Powertrain > Engine and ECT > Clear DTCs

Powertrain > Engine and ECT > Clear DTCs

Result


Proceed to
NEXT

Result


Result	Proceed to
DTC B279C is not output	A
DTC B279C is output	B

A

USE SIMULATION METHOD TO CHECK

B

REPLACE CURRENT ECM WITH PROPER ECM

Replace the current ECM with the proper ECM.
for 1AD-FTV:Click here
for 1ND-TV:Click here
for 1NR-FE:Click here
for 1ZR-FAE:Click here

Result


Proceed to
NEXT