CAN COMMUNICATION SYSTEM(w/ Central Gateway ECU) DATA LIST / ACTIVE TEST

  1. Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    DATA LIST

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Central Gateway / Data List.

      Body Electrical > Central Gateway > Data List

      Tester Display

      IG2 SW

      IG1 SW

      ACC SW

      +B Voltage

      Number of DTC

    5. Read the Data List.

      Body Electrical > Central Gateway > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      IG2 SW

      Ignition switch ON (IG) signal (IG2 terminal)

      OFF or ON

      OFF: Ignition switch ACC or off

      ON: Ignition switch ON (IG)

      IG1 SW

      Ignition switch ON (IG) signal (IG1 terminal)

      OFF or ON

      OFF: Ignition switch ACC or off

      ON: Ignition switch ON (IG)

      ACC SW

      Ignition switch ACC signal (ACC terminal)

      OFF or ON

      OFF: Ignition switch off

      ON: Ignition switch ACC or ON (IG)

      +B Voltage

      Battery voltage (BATT terminal)

      Over 8 V or Under 8 V

      Over 8 V: Battery voltage 8 V or higher

      Under 8 V: Battery voltage below 8 V

      Number of DTC

      Number of DTCs

      0 to 255

      0: Normal