REAR SHOCK ABSORBER(for Double Wishbone Type Suspension) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE REAR WHEEL

2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)

   Click here

3. REMOVE REAR SUSPENSION ARM COVER

   Click here

4. REMOVE REAR ABSORBER CAP

   1. 

      Disengage the 2 claws to remove the rear absorber cap.

5. REMOVE REAR SHOCK ABSORBER CUSHION RETAINER

   1. 

      *a	Wooden Block
      *b	Jack

      Using a jack and wooden block, jack up the rear No. 2 suspension arm assembly.

      CAUTION:

      Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

      Note:

      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

      • Make sure to perform this operation with the vehicle kept as low as possible.

      • Keep supporting the rear No. 2 suspension arm assembly with a jack until the installation of the rear shock absorber assembly has been completed.

   2. 

      Using a 6 mm hexagon socket wrench, secure the rear shock absorber rod and remove the lock nut using a wrench.

      Note:

      Securely insert the 6 mm hexagon socket wrench into the rear shock absorber assembly rod to prevent damage to the rear shock absorber assembly when removing the lock nut.

   3. 

      Remove the rear shock absorber cushion retainer.

6. REMOVE REAR SUSPENSION SUPPORT

   1. Remove the rear suspension support.

7. REMOVE REAR SHOCK ABSORBER ASSEMBLY

   1. 

      Remove the bolt, nut and rear shock absorber assembly with rear No. 1 spring bumper while compressing the rear shock absorber assembly.

      Note:

      Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.

8. REMOVE REAR NO. 1 SPRING BUMPER

   1. 

      Remove the rear No. 1 spring bumper from the rear shock absorber assembly.