POWER DOOR LOCK CONTROL SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body or Master Switch / Data List / All Data.

    5. Read the Data List according to the display on the GTS.

      Body Electrical > Main Body > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Key Unlock Warning SW

      Unlock warning switch

      ON or OFF

      ON: Ignition key inserted

      OFF: Ignition key not inserted

      *1

      ACC SW

      Ignition switch ACC signal

      ON or OFF

      ON: Ignition switch ACC

      OFF: Ignition switch off

      "ON" is also displayed for this item when the ignition switch is ON.

      IG SW

      Ignition switch ON signal

      ON or OFF

      ON: Ignition switch ON

      OFF: Ignition switch off

      "OFF" is also displayed for this item when the ignition switch is ACC.

      RR Door Courtesy SW

      Rear door courtesy light switch RH signal

      ON or OFF

      ON: Rear door RH open

      OFF: Rear door RH closed

      -

      RL Door Courtesy SW

      Rear door courtesy light switch LH signal

      ON or OFF

      ON: Rear door LH open

      OFF: Rear door LH closed

      -

      Back Door Courtesy SW

      Back door courtesy switch signal

      ON or OFF

      ON: Back door open

      OFF: Back door closed

      -

      Back Door Open

      Back door lock signal

      Permit or Prohibit

      Permit: Back door unlocked

      Prohibit: Back door locked

      -

      Door Lock SW-Lock

      Door control switch (power window regulator master switch assembly) lock signal

      ON or OFF

      ON: Lock side of door control switch (power window regulator master switch assembly) pushed

      OFF: Lock side of door control switch (power window regulator master switch assembly) not pushed

      -

      Door Lock SW-Unlock

      Door control switch (power window regulator master switch assembly) unlock signal

      ON or OFF

      ON: Unlock side of door control switch (power window regulator master switch assembly) pushed

      OFF: Unlock side of door control switch (power window regulator master switch assembly) not pushed

      -

      Door Key SW-Lock

      Driver door key-linked lock/unlock switch lock signal

      ON or OFF

      ON: Driver door key cylinder turned to lock position

      OFF: Driver door key cylinder not turned to lock position

      -

      Door Key SW-Unlock

      Driver door key-linked lock/unlock switch unlock signal

      ON or OFF

      ON: Driver door key cylinder turned to unlock position

      OFF: Driver door key cylinder not turned to unlock position

      -

      FR Door Lock Pos

      Front door RH unlock detection switch signal

      LOCK or UNLOCK

      LOCK: Front door RH locked

      UNLOCK: Front door RH unlocked

      -

      FR Door Courtesy SW

      Front door courtesy light switch RH signal

      ON or OFF

      ON: Front door RH open

      OFF: Front door RH closed

      -

      FL Door Lock Pos

      Front door LH unlock detection switch signal

      LOCK or UNLOCK

      LOCK: Front door LH locked

      UNLOCK: Front door LH unlocked

      *2

      FL Door Courtesy SW

      Front door courtesy light switch LH signal

      ON or OFF

      ON: Front door LH open

      OFF: Front door LH closed

      -

      Back Door Open Handle SW

      Back door opener switch signal

      ON or OFF

      ON: Back door opener switch pushed

      OFF: Back door opener switch not pushed

      -

      RR-Door Lock Pos SW

      Rear door RH and LH unlock detection switch signal

      ON or OFF

      ON: Rear door RH or LH unlocked

      OFF: Rear door RH and LH locked

      *2, *3

      RL-Door Lock Pos SW

      Rear door RH and LH unlock detection switch signal

      ON or OFF

      ON: Rear door RH or LH unlocked

      OFF: Rear door RH and LH locked

      *2, *4

      Auto Lock

      Speed-sensitive automatic door lock function

      ON or OFF

      Customized value displayed

      -

      Auto Lock/Shift

      Shift-linked automatic door lock function

      ON or OFF

      Customized value displayed

      *5

      Auto Unlock/Shift

      Shift-linked automatic door unlock function

      ON or OFF

      Customized value displayed

      *5

      All Unlock/Open-Close

      Driver door-linked automatic door unlock function

      ON or OFF

      Customized value displayed

      -

      • *1: w/o Entry and Start System

      • *2: w/ Entry and Start System or Theft Deterrent System or Double Locking System

      • *3: When checking RR-Door Lock Pos SW, make sure to check it with the rear door LH locked.

      • *4: When checking RL-Door Lock Pos SW, make sure to check it with the rear door RH locked.

      • *5: except Manual Transaxle

  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Active Test.

    5. Perform the Active Test according to the display on the GTS.

      Body Electrical > Main Body > Active Test

      Tester Display

      Measurement Item

      Control Range

      Diagnostic Note

      Door Lock

      Door lock motor

      OFF/Unlock/Lock

      -

      Trunk and Back-Door Open

      Back door lock motor

      OFF/ON

      -