NAVIGATION SYSTEM(for HDD) Vehicle Position Mark is not Updated

DTC Code DTC Name
Vehicle Position Mark is not Updated

PROCEDURE

  1. CHECK HARD DISK DRIVE (OPERATION CHECK)

    1. E208267C02

      *a

      Result

      Enter the "Failure Diagnosis" screen

      Click here

    2. Select "HDD Check" and check the result.

      OK

      "OK" is displayed.

      Tip:

      After "HDD Check" is selected, it may take a while until the result is displayed.

      Result

      Result

      OK

      NG
    NG

    REPLACE HARD DISK DRIVE

    Click here

    OK

  2. CHECK CABIN

    1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

      Tip:

      • A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

      • The navigation system may not operate normally when the temperature is -20°C (-4°F) or less, or 65°C (149°F) or higher.

      OK

      Condensation is not likely being produced and the temperature is not high or extremely low.

      Result

      Result

      OK

      NG
    NG

    SET CABIN TO APPROPRIATE TEMPERATURE

    OK

  3. CHECK VEHICLE SENSOR (OPERATION CHECK)

    1. E176549

      Enter the "Vehicle Sensors" screen

      Click here

    2. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.

      OK

      The readings are almost equal.

      Result

      Result

      OK

      NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Click here

    NG

    CHECK DTC OUTPUT

    Click here

    Body Electrical > Navigation System > Trouble Codes