REAR BRAKE(except 4-Pot Caliper) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear brake removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Rear disc (Including removal and installation) Parking brake bedding Electric parking brake system

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides, except where indicated.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  3. REMOVE REAR DISC BRAKE PAD

    Click here

  4. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM

    Click here

  5. DISCONNECT REAR FLEXIBLE HOSE


    1. B006A0L

      Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly LH.

  6. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. B006GSU

      Remove the 2 bolts and rear disc brake cylinder assembly LH from the rear axle carrier sub-assembly LH.

  7. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG


    1. Remove the parking brake shoe adjusting hole plug from the rear disc LH.

  8. REMOVE REAR DISC LH


    1. B006GW1C01
      *a Matchmark

      Put matchmarks on the rear disc LH and the rear axle hub and bearing assembly LH.

      Tech Tips

      Not required when replacing the rear disc LH.

    2. B006G7WC01
      B006DHE Contract

      Release the parking brake and remove the rear disc LH.

      Tech Tips

      If the rear disc LH cannot be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.