HAZARD WARNING SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  2. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. REMOVE COWL SIDE TRIM BOARD LH

    Click here

  5. REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY

    Click here

  6. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  7. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH

    Click here

  8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  9. REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY

    Click here

  10. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

    Click here

  11. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    1. B006F1J

      Disconnect the connector.

    2. B006DR3C01
      *a Rib
      *b Lower Side Claw
      B006GBM Protective Tape
      B006BJ7 Push Here
      B006DHE Remove in this Direction

      Insert a thin-bladed screwdriver, into the cutout of the instrument cluster finish panel garnish assembly.

      Tech Tips

      Tape the thin-bladed screwdriver tip before use.

    3. Slightly tilt the inserted screwdriver to raise the rib and detach the claw on the upper side.

    4. Press the area shown in the illustration to detach the claw on the lower side, and then remove the hazard warning signal switch assembly.