BACK DOOR COURTESY SWITCH INSTALLATION

PROCEDURE

1. INSTALL BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH)

   Tech Tips

   
   

   • When installing a new back door lock assembly (back door courtesy switch), if there is a rope on the assembly, remove the rope before installation.

   • The rope can be removed from the back door lock assembly (back door courtesy switch) by pulling either one of the 2 ends.

   
   

   1. w/o Power Back Door:

      
      

      1. Apply MP grease to the sliding parts of the back door lock assembly (back door courtesy switch).

      2. Install the back door lock assembly (back door courtesy switch) with the 3 bolts.

         Torque:

         13 N*m  { 133 kgf*cm, 10 ft.*lbf }

      3. Connect the connector.

   2. w/ Power Back Door:

      
      

      1. Apply MP grease to the sliding parts of the back door lock assembly (back door courtesy switch).

      2. Install the back door lock assembly (back door courtesy switch) with the 4 bolts.

         Torque:

         13 N*m  { 133 kgf*cm, 10 ft.*lbf }

      3. Connect the connector and attach the clamp.

2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

   Click here

3. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)

   Click here

4. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)

   Click here

5. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)

   Click here

6. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)

   Click here

7. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)

   Click here

8. INSTALL PULL HANDLE (w/ Power Back Door)

   Click here

9. INSTALL BACK DOOR SIDE GARNISH LH

   Click here

10. INSTALL BACK DOOR SIDE GARNISH RH

    Click here

11. INSTALL CENTER BACK DOOR GARNISH

    Click here