FRONT AXLE HUB ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE FRONT WHEEL

  2. DISCONNECT FRONT FLEXIBLE HOSE

    Click here

  3. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  4. REMOVE FRONT DISC

    Click here

  5. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    C130490

    1. Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.

      Maximum

      0.05 mm (0.00197 in.)

      Note:

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the front axle hub sub-assembly.

  6. INSPECT FRONT AXLE HUB RUNOUT

    C130489

    1. Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front hub bolt.

      Maximum

      0.05 mm (0.00197 in.)

      Note:

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the runout is more than the maximum, replace the front axle hub sub-assembly.

  7. INSTALL FRONT DISC

    Click here

  8. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click hereClick hereClick here

  9. CONNECT FRONT FLEXIBLE HOSE

    Click hereClick hereClick here

  10. INSTALL FRONT WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf