HEATER ASSEMBLY REMOVAL

PROCEDURE

  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

  2. REMOVE WATER GUARD PLATE LH

  3. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

  4. SEPARATE DIFFERENTIAL PRESSURE SENSOR ASSEMBLY (for 1AD-FTV)

  5. REMOVE OUTER COWL TOP PANEL

  6. REMOVE FRONT FLOOR COVER RH

    1. E320753C01
      V100135

      Bolt

      V100136

      Clip

      Remove the bolt and clip.

    2. Disengage the 3 clips to remove the front floor cover RH.

  7. REMOVE AIR DUCT

    1. E266021

      Remove the clip and air duct.

  8. REMOVE NO. 1 EXHAUST PIPE SUB-ASSEMBLY

    1. E266022

      Remove the 3 nuts and No. 1 exhaust pipe sub-assembly.

  9. REMOVE NO. 2 HEAT EXCHANGER UNIT GASKET

    1. Remove the No. 2 heat exchanger unit gasket.

  10. REMOVE HEATER AND ACCESSORY ASSEMBLY

    1. E266023

      Disconnect the connector.

    2. Using pliers, grip the claws of the clips and slide the 3 clips to disconnect each hose.

    3. Disengage the clamp.

    4. E266024

      Remove the 3 nuts and heater and accessory assembly.