HIGH INTENSITY DISCHARGE HEADLIGHT BULB REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION

    Click hereClick here

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

    CAUTION:

    The headlight light control ECU sub-assembly may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the headlight light control ECU sub-assembly is not hot before starting work.

    1. Disconnect the connector.

    2. E260879

      Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow in the illustration to disconnect it.

      Note:

      • Do not apply excessive force using a tool.

      • Do not damage the O-ring or allow it to become contaminated with foreign matter. If the O-ring is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly.

    3. E260878

      Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow in the illustration to remove it.

      Note:

      Do not pull the headlight light control ECU sub-assembly with the socket connected.

  4. REMOVE DISCHARGE HEADLIGHT BULB

    Click here