CONDENSER(for 1AD-FTV) INSTALLATION
PROCEDURE
INSTALL CONDENSER WITH RECEIVER ASSEMBLY
-
Engage the 2 guides to install the condenser with receiver assembly as shown in the illustration.
Note:Do not damage the condenser with receiver assembly or radiator when installing the condenser with receiver assembly.
Tip:If a new condenser with receiver assembly is installed, add compressor oil to the condenser with receiver assembly as follows.
Capacity
Add 40 cc (1.35 fl. oz.)
Compressor Oil
ND-OIL 8 or equivalent
Install the bolt.
8.0 N*m
82 kgf*cm
71 in.*lbf
-
CONNECT AIR CONDITIONER TUBE ASSEMBLY
Remove the vinyl tape from the air conditioner tube assembly and the connecting part of the condenser with receiver assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.
Compressor Oil
ND-OIL 8 or equivalent
Install the O-ring to the air conditioner tube assembly.
Install the air conditioner tube assembly to the condenser with receiver assembly with the bolt.
5.4 N*m
55 kgf*cm
48 in.*lbf
CONNECT DISCHARGE HOSE SUB-ASSEMBLY
Remove the vinyl tape from the discharge hose sub-assembly and the connecting part of the condenser with receiver assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.
Compressor Oil
ND-OIL 8 or equivalent
Install the O-ring to the discharge hose sub-assembly.
Install the discharge hose sub-assembly to the condenser with receiver assembly with the bolt.
5.4 N*m
55 kgf*cm
48 in.*lbf
INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY LH
INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY RH
INSTALL RADIATOR SUPPORT LH
INSTALL RADIATOR SUPPORT RH
INSTALL HEADLIGHT ASSEMBLY RH
CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
WARM UP ENGINE
INSPECT FOR REFRIGERANT LEAK