TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. REMOVE NO. 2 CYLINDER HEAD COVER

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  4. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  5. REMOVE BATTERY

  6. REMOVE BATTERY TRAY

  7. REMOVE FRONT BATTERY BRACKET

    Click here

  8. REMOVE BATTERY BRACKET REINFORCEMENT

    Click hereClick here

  9. REMOVE AIR CLEANER CAP AND HOSE

    Click here

  10. REMOVE AIR CLEANER CASE

    Click here

  11. REMOVE FRONT FLOOR COVER

    Click hereClick here

  12. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

    Click here

  13. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    1. Move the shift lever to N.

    2. C203403

      Disconnect the end of the transmission control cable assembly from the shift lever.

    3. C127813C02

      *1

      Stopper

      *2

      Nut

      Pull out the stopper of the transmission control cable assembly.

    4. Rotate the nut of the transmission control cable assembly counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever retainer.

      Note:

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

    5. C279770

      Remove the nut and disconnect the control cable assembly from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.

    7. C201443

      Disconnect the transmission control cable assembly from the control cable support.

    8. C131876

      Remove the bolt and disconnect the clamp of the transmission control cable assembly.

    9. C127837

      Remove the 2 bolts and disconnect the transmission control cable assembly.

    10. Pull out the transmission control cable assembly to remove it.