WASHER NOZZLE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE HOOD INSULATOR (w/ Heater)

    Click here

  2. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)


    1. B0086SWC01
      *a Protective Tape
      B00847Z Remove in this Direction (1)
      B008776 Remove in this Direction (2)

      Using a screwdriver, disengage the 2 claws as indicated by the arrows, in the order shown in the illustration to separate the washer nozzle sub-assembly.

      Note

      Be careful not to damage the windshield glass.

      Tech Tips

      Tape the screwdriver tip before use.

    2. B0089KM

      Disconnect the washer hose to remove the washer nozzle sub-assembly.

      Note

      Washer nozzle sub-assemblies cannot be reused.

  3. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/ Heater)


    1. B0083S6

      Disconnect the connector.

    2. Disconnect the washer hose.

    3. Disengage the clamp.

    4. B0087HV

      Tie a string to the washer hose and wire harness of the washer nozzle sub-assembly.

    5. B0087O2C01
      B00847Z Remove in this Direction (1)
      B008776 Remove in this Direction (2)

      Using a moulding remover, disengage the 2 claws as indicated by the arrows, in the order shown in the illustration to separate the washer nozzle sub-assembly.

      Note

      Be careful not to damage the windshield glass.

    6. Pull the washer nozzle sub-assembly from the hood sub-assembly to remove it.

      Note


      • Washer nozzle sub-assemblies cannot be reused.

      • Leave the string inside the hood sub-assembly.

    7. Remove the string from the washer hose and wire harness of the washer nozzle sub-assembly.