FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

  1. INSTALL TIMING CHAIN COVER OIL SEAL

    1. A322224C01
      V100144

      Apply engine oil

      Apply engine oil to the lip of a new timing chain cover oil seal.

    2. A322225N01

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly edge.

      Standard Depth

      -0.5 to 1.0 mm (-0.0197 to 0.0394 in.)

      09223-22010

      Note:

      Do not tap in the timing chain cover oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY

    1. Align the crankshaft timing gear key with the key groove of the crankshaft pulley.

    2. Using SST, hold the crankshaft pulley in place and tighten the crankshaft pulley set bolt.

      09960-10010

      09962-01000

      09963-01000

      170 N*m

      1734 kgf*cm

      125 ft.*lbf

  3. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

    1. Temporarily install the engine mounting insulator sub-assembly RH to the vehicle body with the 3 bolts.

    2. Install the engine mounting insulator sub-assembly RH to the timing chain cover sub-assembly with the 2 bolts and nut.

      52 N*m

      530 kgf*cm

      38 ft.*lbf

    3. A322519N02

      Fully tighten the 3 bolts in the order shown in the illustration.

      52 N*m

      530 kgf*cm

      38 ft.*lbf

    4. Lower the engine, and remove the jack.

  4. INSTALL OIL FILTER BRACKET

    1. A322755

      Install a new oil filter bracket gasket to the timing chain cover sub-assembly.

    2. A325915

      Install the oil filter bracket with the 3 bolts.

      24 N*m

      245 kgf*cm

      18 ft.*lbf

  5. INSTALL V-RIBBED BELT

    Click here

  6. INSPECT FOR OIL LEAK

  7. INSTALL FRONT FENDER LINER RH

    1. Install the front fender liner RH with the 3 bolts, 2 screws and 2 clips.

  8. INSTALL FRONT WHEEL RH

    Click here