FUEL SYSTEM


  1. CONSTRUCTION


    1. A high efficiency 1-plunger type fuel pump assembly (for high pressure side) is used to reduce drive torque.

    2. The fuel pump assembly (for high pressure side) consists of the following parts:


      1. A spill control valve which adjusts the discharged amount of high pressure fuel.

      2. A plunger which is driven by the camshaft to pressurize the fuel.

      3. A check valve which mechanically opens and closes the path to the fuel delivery pipe assembly (for direct injection).

      4. A relief valve which discharges fuel when the fuel pressure becomes too high in the high-pressure fuel system.

    3. A roller lifter (fuel pump lifter assembly) is used to drive the plunger. As a result, high engine output and high fuel pressure are supported.

    4. The fuel pump assembly (for high pressure side) is installed to the camshaft bearing cap via the cylinder head cover sub-assembly and is driven by the cam installed to the exhaust camshaft (No. 2 camshaft).

    5. A fuel pressure pulsation damper is installed inside the fuel pump assembly (for high pressure side).

    6. The high pressure fuel pressure is variably controlled between 2.4 and 20 MPa according to driving conditions to reduce friction losses.

    7. A metal touch taper seal is used for the fuel pipe (for high pressure) fastener.

      B0022V5C01
      *1 Spill Control Valve *2 Roller Lifter (Fuel Pump Lifter Assembly)
      *3 Fuel Pressure Sensor (for High Pressure) *4 Fuel Delivery Pipe Assembly (for Direct Injection)
      *5 Fuel Injector Assembly (for Direct Injection) *6 Fuel Tank Assembly
      *7 Fuel Main Valve Assembly (for High Pressure) *8 Fuel Main Valve Assembly (for Low Pressure)
      *9 Fuel Filter *10 Fuel Pump (for Low Pressure Side)
      *11 Fuel Suction Filter *12 Fuel Pump Assembly (for High Pressure Side)
      *13 Fuel Pressure Pulsation Damper *14 Plunger
      *15 Check Valve *16 Relief Valve
      *17 Camshaft (Cam to Drive Fuel Pump Assembly (for High Pressure)) - -
      *a High-pressure Fuel System (to Fuel Delivery Pipe (for Direct Injection)) *b Low-pressure Fuel System (from Fuel Tank Assembly)
      *c To Fuel Delivery Pipe with Sensor Assembly (for Port Injection) *d Pipe of High-pressure Fuel System

  2. OPERATION


    1. The plunger moves vertically to pressurize the fuel. The fuel is controlled to the necessary fuel pressure by closing the spill control valve, which is installed on the suction side of the fuel pump assembly (for high pressure side), at the optimal timing during the compression stroke. When the spill control valve closes early, the effective stroke of the plunger becomes longer, increasing the fuel pressure.

    2. The fuel, which is pressurized by the plunger and controlled to between 2.4 and 20 MPa, pushes open the check valve and is pressure-fed to the fuel delivery pipe assembly (for direct injection).

    3. The fuel pressure is detected by the fuel pressure sensor installed in the fuel delivery pipe assembly (for direct injection) and feedback control is performed by the ECM to control the fuel pressure to the target value.

    4. When the fuel pressure becomes too high in the high-pressure fuel system, the relief valve opens to discharge fuel and suppress the fuel pressure to or below the rated working pressure of the system.

      B00231IE04