BRAKE BOOSTER(w/o ABS) REMOVAL

CAUTION / NOTICE / HINT

Note

Make sure to release the vacuum from the brake booster before removing the brake master cylinder sub-assembly from the brake booster assembly.

PROCEDURE


  1. DRAIN BRAKE FLUID

    Note

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  2. REMOVE BRAKE PEDAL RETURN SPRING

    Click here

  3. REMOVE PUSH ROD PIN

    Click here

  4. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS


    1. Loosen the push rod clevis lock nut.

    2. Remove the brake master cylinder push rod clevis.

  5. DISCONNECT VACUUM HOSE


    1. Slide the clip and disconnect the 2 vacuum hoses from each brake vacuum check valve assembly.

  6. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  7. REMOVE BRAKE BOOSTER ASSEMBLY


    1. Remove the 2 brake vacuum check valve assemblies from the brake booster assembly.

    2. Remove the 2 grommets from the brake booster assembly.

    3. B0028US

      Remove the 4 nuts.

    4. Pull out the brake booster assembly with the brake booster gasket.

      Note

      Do not damage the brake lines.

  8. REMOVE BRAKE BOOSTER GASKET