STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)

    Click here

  2. INSTALL STEERING WHEEL BOSS LOWER COVER

    1. w/o Shift Paddle Switch

      1. Attach the 2 guide pins and 4 claws to install the lower cover.

    2. w/ Shift Paddle Switch

      1. Attach the 2 guide pins and 2 claws to install the lower cover.

      2. Install the 2 screws.

  3. INSTALL STEERING PAD SWITCH ASSEMBLY

    1. Attach the 6 claws and 2 pins to install the steering pad switch assembly.

    2. Install the 2 screws.

    3. Connect the connector to the spiral cable.

      Tip:

      If the vehicle is equipped with a shift paddle switch, connect the connector and the connector clamp.

  4. INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)

    1. Install the cruise control switch wire to the cruise control main switch.

  5. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  7. ADJUST SPIRAL CABLE

    for Single Type:Click here

    for Dual Type:Click here

  8. INSTALL STEERING WHEEL ASSEMBLY

    1. Align the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      50 N*m

      510 kgf*cm

      37 ft.*lbf

    3. Connect the connectors to the spiral cable sub-assembly.

  9. INSTALL STEERING PAD

    for Single Type:Click here

    for Dual Type:Click here

  10. INSPECT STEERING WHEEL CENTER POINT

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

  12. CHECK SRS WARNING LIGHT

    w/ Occupant Classification System:Click here

    w/o Occupant Classification System:Click here