EXHAUST GAS TEMPERATURE SENSOR INSTALLATION

PROCEDURE

  1. INSTALL NO. 2 EXHAUST GAS TEMPERATURE SENSOR

    Note:

    If the No. 2 exhaust gas temperature sensor is dropped, replace it with a new one.

    1. Using a 14 mm union nut wrench, install the No. 2 exhaust gas temperature sensor to the exhaust manifold converter sub-assembly.

      30 N*m

      306 kgf*cm

      22 ft.*lbf

      Note:

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

      Click hereClick here

    2. Engage the No. 2 exhaust gas temperature sensor connector clamp.

  2. INSTALL NO. 3 EXHAUST GAS TEMPERATURE SENSOR

    Note:

    If the No. 3 exhaust gas temperature sensor is dropped, replace it with a new one.

    1. A263934C01

      *1

      White Tube

      *2

      Protective Tube

      Temporarily install the No. 3 exhaust gas temperature sensor.

    2. Engage the No. 3 exhaust gas temperature sensor connector clamp.

    3. Temporarily install the No. 3 exhaust gas temperature sensor connector clamp with the nut.

      Note:

      Make sure the clamp is aligned with the white tube of the wire harness as shown in the illustration.

    4. Tighten the nut.

      6.4 N*m

      65 kgf*cm

      57 in.*lbf

    5. Using a 14 mm union nut wrench, install the No. 3 exhaust gas temperature sensor.

      30 N*m

      306 kgf*cm

      22 ft.*lbf

      Note:

      • When tightening the union nut, make sure that the protective tube of the No. 3 exhaust gas temperature sensor is within the area shown in the illustration.

      • Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

        Click hereClick here

  3. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

    Click here

  4. INSTALL NO. 4 MANIFOLD CONVERTER INSULATOR

    Click here

  5. INSTALL ENGINE ASSEMBLY

    Click here

  6. INSTALL EXHAUST GAS TEMPERATURE SENSOR

    Note:

    If the exhaust gas temperature sensor is dropped, replace it with a new one.

    1. Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

      30 N*m

      306 kgf*cm

      22 ft.*lbf

      Note:

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

      Click hereClick here

    2. Engage the exhaust gas temperature sensor connector clamp.

  7. INSTALL NO. 1 ENGINE COVER

    Click here