TRANSMISSION WIRE REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01DYS2E01

    Note

    Some fluid will remain in the oil pan.


    1. Remove the 20 bolts.

    2. A01DVHOE01

      Examine the particles in the pan.


      1. Remove the magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bushing wear

  4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

    A01DUXAE01

    1. Remove the 4 bolts and oil strainer.

      Note

      Be careful as some fluid will come out of the oil strainer.

  5. SEPARATE TRANSMISSION WIRE

    A01DZYCE01

    1. Remove the 2 bolt and clamp.

    2. Disconnect the ATF temperature sensor.

    3. Disconnect the 7 connectors from the solenoid valves.

  6. REMOVE TRANSMISSION WIRE

    A01E043

    1. Disconnect the transmission wire connector.

    2. Remove the bolt and pull out the transmission wire.