MANUAL TRANSAXLE SYSTEM

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

  • Use the following procedure to troubleshoot the manual transaxle system.

  • *: Use the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT
    NEXT

  2. CUSTOMER PROBLEM ANALYSIS

    Click hereClick hereClick here

    Result

    Proceed to

    NEXT
    NEXT

  3. INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage.

      Standard Voltage

      11 to 14 V

      Tip:

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    Result

    Proceed to

    NEXT
    NEXT

  4. CHECK CAN COMMUNICATION SYSTEM*

    1. Using the GTS, check if the CAN communication system is functioning normally.

      CAN Bus Check

    Tip:

    • Refer to CAN Bus Check in CAN Communication System.

      w/o Central Gateway ECU:Click hereClick hereClick here

      w/ Central Gateway ECU:Click hereClick here

    • The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there are no malfunctions in the CAN communications system.

    Result

    Result

    Proceed to

    CAN communication system DTCs are not output.

    A

    CAN communication system DTCs are output.

    B
    B

    GO TO CAN COMMUNICATION SYSTEM

    w/o Central Gateway ECU:Click here

    w/ Central Gateway ECU:Click here

    A

  5. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*

    1. Refer to DTC Check/Clear.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  6. SELECT CHECK MODE DIAGNOSIS*

    1. Refer to Check Mode Procedure.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  7. CHECK FOR DTC*

    1. Proceed to DTC Check/Clear.

      Click here

      Powertrain > Transmission > Trouble Codes

    Result

    Result

    Proceed to

    DTCs are not output.

    A

    DTCs are output.

    B
    B

    DIAGNOSTIC TROUBLE CODE CHARTClick here

    A

  8. SYMPTOM SIMULATION

    1. Refer to Symptom Simulation.

      Click hereClick hereClick here

    Result

    Proceed to

    NEXT
    NEXT

  9. COMPONENT INSPECTION

    Result

    Proceed to

    NEXT
    NEXT

  10. REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  11. CONFIRMATION TEST

    Result

    Proceed to

    NEXT
    NEXT

    END

  12. DIAGNOSTIC TROUBLE CODE CHART

    1. Proceed to Diagnostic Trouble Code Chart.

      Click hereClick here

    Result

    Proceed to

    NEXT
    NEXT

  13. CIRCUIT INSPECTION*

    Result

    Proceed to

    NEXT
    NEXT

  14. IDENTIFICATION OF PROBLEM

    Result

    Proceed to

    NEXT
    NEXT

  15. REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  16. CONFIRMATION TEST

    Result

    Proceed to

    NEXT
    NEXT

    END