EXHAUST FUEL ADDITION INJECTOR REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE NO. 1 ENGINE COVER

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. DISCONNECT WIRE HARNESS

    1. A263936

      Disconnect the 5 connectors and 3 wire harness clamps.

    2. Remove the bolt from the fuel hose protector.

  7. REMOVE WIRE HARNESS CLAMP BRACKET

    1. A263990

      Remove the bolt and wire harness clamp bracket.

  8. REMOVE FUEL HOSE PROTECTOR

    1. A197570

      Remove the bolt and fuel hose protector.

  9. REMOVE FUEL TUBE SUB-ASSEMBLY

    Click here

  10. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

    1. A201783C01

      *1

      Washer

      *2

      Nozzle Holder Clamp

      Remove the bolt, washer, nozzle holder clamp, exhaust fuel addition injector assembly and gasket.

  11. REMOVE FUEL INJECTOR SEAL

    1. A201784C01

      *1

      Fuel Injector Seal

      Remove the fuel injector seal from the exhaust fuel addition injector assembly.