REAR AXLE HUB(for Torsion Beam Type Suspension) INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

    1. Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle beam assembly with the new 4 bolts.

      90 N*m

      918 kgf*cm

      66 ft.*lbf

  2. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT REAR AXLE HUB RUNOUT

    Click here

  4. CONNECT SKID CONTROL SENSOR WIRE

    Click here

  5. INSTALL REAR DISC

    Click here

  6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  8. ADJUST PARKING BRAKE

    Click here

  9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  10. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf

  11. CHECK FOR SPEED SENSOR SIGNAL

    w/o VSC:Click here

    w/ VSC:Click here