CLUTCH UNIT(for EC61) INSPECTION

PROCEDURE

  1. INSPECT CLUTCH DISC ASSEMBLY

    C187769

    1. Using a vernier caliper, measure the rivet head depth.

      Minimum Rivet Depth

      0.3 mm (0.0118 in.)

      If necessary, replace the clutch disc assembly.

    2. Install the clutch disc assembly to the manual transaxle assembly.

      Tip:

      Insert the clutch disc assembly in the correct direction.

    3. C187770

      Using a dial indicator, measure the clutch disc assembly runout.

      Maximum Runout

      0.8 mm (0.0315 in.)

      If necessary, replace the clutch disc assembly.

  2. INSPECT CLUTCH COVER ASSEMBLY

    D029069N02

    1. Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

      Maximum

      A (Depth): 0.5 mm (0.0197 in.)

      B (Width): 6.0 mm (0.236 in.)

      If necessary, replace the clutch cover assembly.

  3. INSPECT FLYWHEEL SUB-ASSEMBLY

    C194341C01

    *a

    80 mm (3.15 in.)

    1. Using a dial indicator, check the flywheel sub-assembly runout as shown in the illustration.

      Maximum Runout

      0.12 mm (0.00472 in.)

      If necessary, replace the flywheel sub-assembly.