FUEL LID LOCK CONTROL (for Single Cab) INSTALLATION

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

INSTALL FUEL FILLER OPENING LID LOCK RETAINER
1. Install the fuel filler opening lid lock retainer and turn it counterclockwise as shown in the illustration.
INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
1. for LHD:
  1. Install the cable and turn the fuel filler opening lid lock retainer clockwise as shown in the illustration.
  2. Attach the cable to the clamps shown in the illustration.
  3. Install the grommet to the vehicle body.
  4. Install the fuel lid lock open lever.
    
    Text in Illustration
    
    *1 Fuel Lid Lock Open Lever *2 Grommet
2. for RHD:
  1. Install the cable and turn the fuel filler opening lid lock retainer clockwise as shown in the illustration.
  2. Attach the cable to the clamps shown in the illustration.
  3. Install the grommet to the vehicle body.
  4. Install the fuel lid lock open lever.
    
    Text in Illustration
    
    *1 Fuel Lid Lock Open Lever *2 Grommet
INSTALL REAR WHEEL HOUSE LINER LH
1. Install the rear wheel house liner.
INSTALL REAR NO. 1 WHEEL OPENING EXTENSION SUB-ASSEMBLY LH (w/ Over Fender)
1. Install 11 new clips to the rear No. 1 wheel opening extension.
2. Attach the 11 clips to install the rear No. 1 wheel opening extension.
3. w/ Mudguard:
  
  Install the 5 screws.
4. w/o Mudguard:
  
  Install the 8 screws.
INSTALL FRONT FLOOR CARPET ASSEMBLY
1. Install the front floor carpet.
INSTALL LOWER QUARTER TRIM PANEL LH
1. Attach the 3 clips and claw to install the lower quarter trim panel.
2. Install the front door opening trim.
3. Connect the front seat outer belt floor anchor with the bolt.
  
  Torque:
  
  42 N*m { 428 kgf*cm, 31 ft.*lbf }
INSTALL COWL SIDE TRIM BOARD LH (for LHD)
1. Attach the 2 clips to install the cowl side trim board.
2. Install the clip.
3. Install the front door opening trim.
INSTALL COWL SIDE TRIM BOARD RH (for RHD)

Tech Tips

Use the same procedure described for the LH side.
INSTALL FRONT DOOR SCUFF PLATE LH
1. Attach the 4 clips and 8 claws to install the front door scuff plate LH.
INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

Tech Tips

Use the same procedure described for the LH side.
INSTALL UPPER BACK PANEL GARNISH
1. Attach the 5 clips, 4 guides and 4 claws to install the upper back panel garnish.
INSTALL CONSOLE BOX ASSEMBLY (w/ Console Box)

Click here
INSTALL FRONT SEAT ASSEMBLY LH
1. w/ Front Seat Side Airbag:
  
  Click here
2. for Separate Seat Type:
  
  Click here
INSTALL FRONT SEAT ASSEMBLY RH
1. w/ Front Seat Side Airbag:
  
  Tech Tips
  
  Use the same procedure described for the LH side.
2. for Separate Seat Type:
  
  Tech Tips
  
  Use the same procedure described for the LH side.
3. for Bench Seat Type:
  
  Click here