FRONT EVAPORATOR TEMPERATURE SENSOR(for VALEO Made) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 1 cooler thermistor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here


  • No. 1 Air Conditioning Radiator Damper Servo Sub-assembly

  • No. 2 Air Conditioning Radiator Damper Servo Sub-assembly

  • Air conditioning amplifier assembly

 Initialize servo motor (Air conditioning system) DTCs are stored

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for the LHD vehicles.

PROCEDURE


  1. REMOVE BLOWER ASSEMBLY

    Click here

  2. REMOVE HEATER COVER (w/o PTC Heater)

    Click here

  3. REMOVE NO. 2 HEATER COVER (w/ PTC Heater)

    Click here

  4. REMOVE QUICK HEATER ASSEMBLY (w/ PTC Heater)

    Click here

  5. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

    Click here

  6. REMOVE AIR CONDITIONING HARNESS ASSEMBLY

    Click here

  7. REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)

    Click here

  8. REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Manual Air Conditioning System)

    Click here

  9. REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

    Click here

  10. REMOVE HEATER PIPE GROMMET

    Click here

  11. REMOVE HEATER CLAMP

    Click here

  12. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

    Click here

  13. REMOVE COOLER EXPANSION VALVE

    Click here

  14. REMOVE HEAT EXCHANGER CASE

    Click here

  15. REMOVE RADIATOR CASE SUB-ASSEMBLY

    Click here

  16. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  17. REMOVE NO. 1 COOLER THERMISTOR


    1. A005PZ0

      Remove the No. 1 cooler thermistor.