REAR AXLE HUB(for Torsion Beam Type Suspension) REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR WHEEL

  2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  3. LOOSEN NO. 2 WIRE ADJUSTING NUT

    Click here

  4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  6. REMOVE REAR DISC

    Click here

  7. DISCONNECT SKID CONTROL SENSOR WIRE

    Click here

  8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

    1. C272869

      Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle beam assembly.