STEERING KNUCKLE INSTALLATION
PROCEDURE
INSTALL STEERING KNUCKLE LH
-
Hold the front axle assembly in a vise between aluminum plates.
Note:When using a vise, do not overtighten it.
Install the front brake dust cover to the steering knuckle.
Install the front axle hub sub-assembly with the 4 bolts.
96 N*m
979 kgf*cm
71 ft.*lbf
Note:Do not place the magnet rotor side of the hub and bearing so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.
-
INSTALL FRONT LOWER BALL JOINT
Hold the front axle assembly in a vise between aluminum plates.
Note:When using a vise, do not overtighten it.
-
Install the front lower ball joint to the front axle assembly with the nut.
133 N*m
1356 kgf*cm
98 ft.*lbf
Install a new cotter pin.
Note:If the holes for the cotter pin are not aligned, align the holes by tightening the nut as necessary up to an additional 60°.
INSTALL FRONT AXLE ASSEMBLY LH
CONNECT FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH
CONNECT TIE ROD END SUB-ASSEMBLY LH
INSTALL FRONT DISC
INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
INSTALL FRONT AXLE SHAFT NUT LH
REMOVE DISC BRAKE CYLINDER ASSEMBLY LH
REMOVE FRONT DISC
INSPECT FRONT AXLE HUB BEARING LOOSENESS
INSPECT FRONT AXLE HUB RUNOUT
INSTALL FRONT DISC
INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
INSTALL FRONT FLEXIBLE HOSE
CONNECT FRONT SPEED SENSOR LH
STAKE FRONT AXLE SHAFT NUT LH
INSTALL FRONT WHEEL
103 N*m
1050 kgf*cm
76 ft.*lbf
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Inspect and adjust the front wheel alignment (Click here).
CHECK SPEED SENSOR SIGNAL