REAR AXLE CARRIER(for 2WD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY


    1. B008M9X

      Temporarily install the rear axle carrier sub-assembly to the rear upper control arm assembly with the bolt and nut.

      Note


      • Insert the bolt with the threaded end facing the rear of the vehicle.

      • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

    2. Temporarily install the rear shock absorber assembly to the rear axle carrier sub-assembly with the nut.

      Note

      Hold the rear axle carrier pin while rotating the nut.

    3. Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts.

      Torque:
      135 N*m  { 1377 kgf*cm, 100 ft.*lbf }

  2. INSTALL FLEXIBLE HOSE BRACKET


    1. Install the flexible hose bracket to the rear axle carrier sub-assembly with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  3. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

    Click here

  4. INSTALL REAR LOWER COIL SPRING INSULATOR

    Click here

  5. INSTALL REAR COIL SPRING

    Click here

  6. STABILIZE SUSPENSION

    Click here

  7. INSTALL REAR UPPER CONTROL ARM ASSEMBLY


    1. Install the rear upper control arm assembly to the rear axle carrier sub-assembly with the bolt.

      Torque:
      73 N*m  { 744 kgf*cm, 54 ft.*lbf }

      Note

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  8. INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

    Click here

  9. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

      Click here

  10. INSTALL REAR SHOCK ABSORBER ASSEMBLY

    Click here

  11. INSTALL REAR STABILIZER LINK ASSEMBLY

    Click here

  12. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

    Click here

  13. CONNECT SKID CONTROL SENSOR WIRE

    Click here

  14. INSTALL REAR DISC

    Click here

  15. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  16. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)

    Click here

  17. INSTALL REAR WHEEL

    Click here

  18. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. Install the rear No. 2 suspension arm assembly (rear suspension member sub-assembly side) with the nut.

      Click here

  19. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  20. CHECK FOR SPEED SENSOR SIGNAL

    Click here

  21. PERFORM INITIALIZATION (w/ Height Control Sensor)

    Click here