BLACK OUT TAPE(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

   Click hereClick hereClick hereClick hereClick here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick hereClick hereClick hereClick hereClick here

3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

   Click here

4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

   Click here

5. REMOVE FRONT DOOR ASSIST GRIP COVER LH

   Click here

6. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

8. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

   Click here

9. REMOVE FRONT DOOR SERVICE HOLE COVER LH

   Click here

10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

11. REMOVE FRONT DOOR GLASS RUN LH

    Click here

12. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

    Click here

13. REMOVE FRONT DOOR WEATHERSTRIP LH

    Click here

14. REMOVE DOOR WINDOW FRAME MOULDING CLIP

    Click here

15. REMOVE FRONT DOOR WINDOW REAR FRAME MOULDING LH

    Click here

16. REMOVE NO. 1 BLACK OUT TAPE LH

    

    Tip:

    When removing the No. 1 black out tape, heat the frontdoor panel and No. 1 black out tape using a heat light.

    Standard

    Item	Temperature
    Front Door Panel	40 to 60°C (104 to 140°F)
    No. 1 Black Out Tape	20 to 30°C (68 to 86°F)

    Note:

    Do not heat the front door panel or No. 1 black out tape excessively.

    1. Pull back an edge of the No. 1 black out tape and pull it parallel to the front door panel to remove it.