PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE

  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Tip:

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.

    1. Clean the bolt and the bolt hole.

    2. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    3. Install the park/neutral position switch assembly to the manual valve shaft.

    4. Temporarily install the bolt.

    5. C155871C02

      *1

      New Lock Washer

      Install a new lock washer and the nut.

      6.9 N*m

      70 kgf*cm

      61 in.*lbf

    6. C260893E01

      Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

    7. D105091C03

      *1

      Neutral Basic Line

      *2

      Groove

      Align the groove with the neutral basic line.

    8. Hold the switch in position and tighten the bolt.

      13 N*m

      130 kgf*cm

      10 ft.*lbf

    9. Using a screwdriver, bend the tabs of the lock washer.

    10. Connect the park/neutral position switch connector.

  2. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    (Click here)