SLIDING ROOF SWITCH ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY


    1. Check the sliding roof switch (map light assembly).


      1. Measure the resistance between each terminal of the sliding roof switch (map light assembly) according to the value (s) in the table below.

        B006A1YC01
        *a

        Component without harness connected

        (Sliding Roof Switch (Map Light Assembly))

        		 - -

        Tech Tips

        If the result is not as specified, replace the sliding roof switch (map light assembly).

        Standard Resistance
        Tester Connection Condition Specified Condition
        N9-15(UP) - N7-22(GND) UP switch ON 100 Ω or less
        N9-15(UP) - N7-22(GND) UP switch OFF 1 kΩ or higher
        N9-16(DOWN) - N7-22(GND) DOWN switch ON 100 Ω or less
        N9-16(DOWN) - N7-22(GND) DOWN switch OFF 1 kΩ or higher
        N9-12(OPN) - N7-22(GND) OPEN switch ON 100 Ω or less
        N9-12(OPN) - N7-22(GND) OPEN switch OFF 1 kΩ or higher
        N9-14(CLS) - N7-22(GND) CLOSE switch ON 100 Ω or less
        N9-14(CLS) - N7-22(GND) CLOSE switch OFF 1 kΩ or higher