CLUTCH PEDAL SWITCH(for RHD) INSPECTION

PROCEDURE

1. INSPECT CLUTCH START SWITCH ASSEMBLY

   
   
   1. 

      Text in Illustration

      *a	9.0 to 10.0 mm (0.354 to 0.394 in.)
      *b	ON
      *c	OFF

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition 1 - 2 ON (Pushed in) Below 1Ω OFF (Released) 10 kΩ or higher

      If the resistance is not as specified, replace the clutch start switch assembly.

2. INSPECT CLUTCH SWITCH ASSEMBLY

   
   
   1. 

      Text in Illustration

      *a	5.0 to 6.5 mm (0.197 to 0.256 in.)
      *b	ON
      *c	OFF

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition 1 - 2 ON (Pushed in) Below 1Ω OFF (Released) 10 kΩ or higher

      If the resistance is not as specified, replace the clutch switch assembly.