GLOW PLUG (w/o EGR System) INSTALLATION


  1. INSTALL GLOW PLUG ASSEMBLY

    A01E1Q6

    1. Using a 12 mm deep socket wrench, install the 4 glow plugs.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  2. INSTALL NO. 1 GLOW PLUG CONNECTOR


    1. Install the glow plug connector by uniformly tightening the 4 nuts.

      Torque:
      2.2 N*m  { 22 kgf*cm, 19 in.*lbf }

    2. Install the 4 screw grommets.

    3. Install the wire harness with the nut.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

  3. INSTALL INTAKE AIR CONNECTOR

    A01DZD1

    1. Install a new gasket and the air connector with the 2 nuts and bolt.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  4. INSTALL THROTTLE BODY BRACKET


    1. Install the bracket with the 3 bolts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  5. INSTALL DIESEL THROTTLE BODY ASSEMBLY

    A01E2KU

    1. Install a new gasket and the throttle body with the 2 bolts and 2 nuts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }
    2. A01DZU2

      Connect the 2 connectors.

  6. INSTALL VACUUM SWITCHING VALVE BRACKET

    A01DWW4

    1. Install the bracket with the 2 bolts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  7. INSTALL NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY

    A01E0K7

    1. Connect the pipe (with the 2 air hoses) and install the bolt.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    2. Tighten the 2 clamps.

    3. Connect the vacuum hose to the gas filter.

    4. Connect the manifold absolute pressure sensor connector.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  9. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.