REAR FLOOR AIRBAG SENSOR INSTALLATION

PROCEDURE

  1. INSTALL REAR FLOOR SIDE AIRBAG SENSOR

    1. Turn the engine switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note:

      • w/ Navigation System:

        After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

        Table 1. Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal

        Condition

        Waiting Time

        Vehicle enrolled in safety connect system

        6 minutes

        Vehicle not enrolled in safety connect system

        1 minute

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here)

    3. Install the rear floor airbag sensor with the bolt.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

      Note:

      • If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that is the rear floor airbag sensor not loose.

    5. Connect the connector.

  2. INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER

    1. Attach the clip and claw to install the cover.

    2. Return the floor carpet to its original position.

  3. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  4. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  5. INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

    Click here

  6. INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

    Click here

  7. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

    Click here

  8. INSTALL REAR NO. 1 SEAT ASSEMBLY

    1. for 60/40 Split Double-folding Seat Type LH Side:

      1. Install the rear No. 1 seat assembly (Click here).

    2. for 60/40 Split Double-folding Seat Type RH Side:

      1. Install the rear No. 1 seat assembly (Click here).

    3. for 60/40 Split Slide Walk-in Seat Type LH Side:

      1. Install the rear No. 1 seat assembly (Click here).

    4. for 60/40 Split Slide Walk-in Seat Type RH Side:

      1. Install the rear No. 1 seat assembly (Click here).

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  10. CHECK SRS WARNING LIGHT

    1. Check the SRS warning light (Click here).