METER / GAUGE SYSTEM, Diagnostic DTC:B1500
| DTC Code | DTC Name |
|---|---|
| B1500 | Fuel Sender Open Detected |
DESCRIPTION
This DTC is stored when the combination meter detects a fuel sender gauge malfunction.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
B1500 |
Fuel Sender Open Detected |
Both conditions are met:
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
When replacing the combination meter assembly, make sure to replace it with a new one.
PROCEDURE
READ VALUE USING GTS (FUEL INPUT)
Using the GTS, read the Data List.
Body Electrical > Combination Meter > Data List
Tester Display
Measurement Item
Range
Normal Condition
Diagnostic Note
Fuel Input
Fuel input signal
Min.: 0 l, Max.: 127.5 l
Current fuel level displayed
-
Body Electrical > Combination Meter > Data List
Tester Display
Fuel Input
OK
Fuel amount value displayed on the GTS is almost the same as the needle indication.
Result
Proceed to
OK
NG
CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE ASSEMBLY)
Disconnect the G16 combination meter assembly connector.
Disconnect the V2 fuel sender gauge assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
G16-16 (L) - V2-1
Always
Below 1 Ω
G16-15 (E) - V2-2
G16-16 (L) or V2-1 - Body ground
Always
10 kΩ or higher
G16-15 (E) or V2-2 - Body ground
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
INSPECT FUEL SENDER GAUGE ASSEMBLY
Remove the fuel sender gauge assembly.
1AD-FTV:Click here
2AD-FHV:Click here
2AD-FTV:Click here
2AR-FE:Click here
3ZR-FAE:Click here
3ZR-FE:Click here
Inspect the fuel sender gauge assembly.
1AD-FTV:Click here
2AD-FHV:Click here
2AD-FTV:Click here
2AR-FE:Click here
3ZR-FAE:Click here
3ZR-FE:Click here
Result
Proceed to
OK
NG (1AD-FTV)
NG (2AD-FHV)
NG (2AD-FTV)
NG (2AR-FE)
NG (3ZR-FAE)
NG (3ZR-FE)