REAR AXLE HUB(for Double Wishbone Type Suspension) REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR WHEEL

  2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click hereClick here

  3. LOOSEN NO. 2 WIRE ADJUSTING NUT

    Click hereClick here

  4. REMOVE PARKING BRAKE LEVER PROTECTOR

    Click hereClick hereClick hereClick here

  5. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  6. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  7. REMOVE REAR DISC

    Click hereClick hereClick here

  8. DISCONNECT SKID CONTROL SENSOR WIRE

    Click hereClick here

  9. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

    1. C211873

      Remove the 4 bolts, rear disc brake dust cover sub-assembly and rear axle hub and bearing assembly from the rear axle carrier sub-assembly.