FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  9. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  10. REMOVE REAR DOOR SCUFF PLATE

    Click here

  11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  12. REMOVE LAP BELT OUTER ANCHOR COVER


    1. B005ZU0

      Disengage the 3 claws and remove the lap belt outer anchor cover.

  13. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. B005ZJQ

      Remove the bolt and disconnect the floor end of the front seat outer belt assembly.

  14. REMOVE CENTER PILLAR LOWER GARNISH

    Click here

  15. REMOVE CENTER PILLAR GARNISH

    Click here

  16. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. B005ZT5

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. B005XIXE03
      Text in Illustration
      *A w/ Pre-crash Safety System
      *1 Pretensioner Connector

      Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect the connector.

    4. w/ Pre-crash Safety System:


      1. Disconnect the connector.

    5. B005YOY

      Remove the 2 bolts and front seat outer belt assembly.

  17. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. B005XFM

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.