REAR BRAKE FLEXIBLE HOSE REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR WHEEL

  2. DRAIN BRAKE FLUID

    Note:

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  3. REMOVE REAR FLEXIBLE HOSE LH

    1. C261228

      Remove the union bolt, gasket and rear flexible hose from the rear disc brake cylinder.

    2. C214597

      Disconnect the brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.

      Note:

      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

    3. Remove the clip.

  4. REMOVE REAR FLEXIBLE HOSE

    1. C217124

      Disconnect each brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.

    2. Remove the 2 clips.

    3. Remove the flexible hose.

    4. C217125

      Disconnect each brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.

    5. Remove the 2 clips.

    6. Remove the rear flexible hose.

  5. REMOVE NO. 5 FLEXIBLE HOSE BRACKET

    1. C217154

      Remove the bolt and bracket from the upper arm bracket.

  6. REMOVE NO. 6 FLEXIBLE HOSE BRACKET

    1. Remove the bolt and bracket from the rear axle housing.