ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. DRAIN ENGINE COOLANT

    B007SCAE01

    CAUTION:

    To avoid the danger of being burned, do not remove the reservoir cap while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.


    1. Loosen the radiator drain plug.

    2. Remove the reservoir cap.

    3. Loosen the cylinder block drain plug and drain the coolant.

    4. Tighten the radiator drain plug.

    5. Tighten the cylinder block drain plug.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

  2. REMOVE WATER TEMPERATURE SENSOR


    1. B007TYIE01

      Disconnect the water temperature sensor connector.

    2. Remove the water temperature sensor and gasket.