SOLAR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the solar sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B008KCO

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for the LHD vehicles.

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE DEFROSTER NOZZLE ASSEMBLY

    Click here

  3. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


    1. B008LFA

      Disconnect the connector.

    2. Disengage the claws to remove the automatic light control sensor.